58 discussions on HomeOwnersHub about the Ridgid TS3650: what owners asked, what went wrong, and what fixed it.
I have a Ridgid TS2424 table saw, that, up until today I havebeen very happy with.But today the following happened which I can only explain oneway.I normally use a thin kerf 10 blade with this saw. Today afterI made some cuts using this...
Howdy all... Pop always said the only dumb question is the one youwon't ask... What is the yellow plastic circle/plug for on the older(possibly newer) C-man a0" contractor style table saws? The plug islocated in the table top right before...
Have any of you with left tilt saws found the fact that the flange reference is on the left side vs right side a problem?I guess this would be an issue with using dado blades or when switching from regular kerf to thin kerf. You'd have to...
I am going to buy a table saw and was looking for some recommendations. I am using it for various household woodworking projects, but nothingtoo fancy - I don't think it would be worth it to spend a whole lot onit considering how much use I...
I'm in the market for the purchase of a cabinet saw. Last summer I burnedup a ryobi direct drive milling cypress for a deck. I promised myself,never again direct drive. I have a chance at a used Delta cabinet saw, 3h,3 belt, 220v with...
I have a small basement shop with steep, narrow stairs that take two bends onthe way down. Because of the difficulty of getting things down the stairs, myshop is equipped with benchtop tools. The only exception is a Delta 6" inchjointer...