Just finished replacing O rings on a moen single lever faucet to improve the swivel on the spout. all went great until I now have very low pressure on the cold water position and the cold range is very small. no leaks good shut off and good hot water pressure. What went wrong? Frank
Faucet prob
Oct 17, 2007
2 Replies
It sounds like something either shifted inside the unit or the unit was reassembled out of alignment.
Have you taken the faucet apart to see if perhaps the ball (if there is one) is centered properly or if a o-ring or other part does not seem to be lined up the symmetrically?
Another option is to remove the 180 deg restriction so the handle can turn full circle and see if it helps ;)
Free men own guns - www(dot)geocities(dot)com/CapitolHill/5357/
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required