Home Repair

76591 Threads Posts
to

E-14 bulb in USA?

Hello everyone. Does anyone know if E-14 bulbs (this socket is called also: european edison screw, european intermediat...
3 comments posted 19yrs
posted by brak
3 comments posted 19yrs posted by brak

Need advice on coaxial cable for home re-wire

I'm planning on rewiring my home to upgrade the coaxial cable running from where the cable comes into the house and...
16 comments posted 19yrs
posted by cottonchipper
16 comments posted 19yrs posted by cottonchipper

Ceramic Tile Grouting ?

Hi, Have a few ceramic tiles, at the end of the run, that are a bit loose due to the grout between them, and presumably...
1 comments posted 19yrs
posted by rgsros
1 comments posted 19yrs posted by rgsros

Allister Garage Door Opener Problem

I am having a problem with my Allister garage door openers. I have what appears to be a single receiver that is connect...
3 comments posted 19yrs
posted by damonl73
3 comments posted 19yrs posted by damonl73

Lintel Beam Bending - Followup

This is an update to my previous post "Lentil Beam Above Garage is Bending". Since then, I've learn the correct spe...
9 comments posted 19yrs
posted by dbfenner
9 comments posted 19yrs posted by dbfenner

water heater pilot

Twice in a year, my water heater's pilot light has gone out and the drip pan overflowed. I cannot tell which causes...
8 comments posted 19yrs
posted by clarkc
8 comments posted 19yrs posted by clarkc

Telephone problems - Help/Advice PLEASE

Was suddenly contronted with the Sunday a.m. and can't find appropriate forum to address it. Verizon is of little/n...
8 comments posted 19yrs
posted by starrin
8 comments posted 19yrs posted by starrin

Electrical installation tubes

I have recently moved into a brand new appartment. I was amazed to find out that every room is equipped with only one U...
17 comments posted 19yrs
posted by marko
17 comments posted 19yrs posted by marko

Single side lever tap

I have a single (right) side lever tap. Problem is that hot/cold water is not regulated by pushing lever left and right...
3 comments posted 19yrs
posted by marko
3 comments posted 19yrs posted by marko

Best belt-sander?

I'm looking for a hand sander, generally I buy Dewalt, but I think that the porta cable model might be the better c...
8 comments posted 19yrs
posted by deanbrown3d
8 comments posted 19yrs posted by deanbrown3d

Deck splintery for baby - and solutions?

I've pressure washed the deck and am about to put down Penofin, but I wonder if people belt-sand the surface first...
5 comments posted 19yrs
posted by deanbrown3d
5 comments posted 19yrs posted by deanbrown3d

Kitchen Aid Superba - chilled water tooooo slow

Anyone know if its possible to adjust the flow rate on the chilled water cup filler on the front of a Kitchen Aid fridge...
2 comments posted 19yrs
posted by deanbrown3d
2 comments posted 19yrs posted by deanbrown3d

stripping cedar deck. Arsenic?

Previous owner painted the cedar deck in our backyard. We're stripping it (with deck stripping chemicals... sodium...
4 comments posted 19yrs
posted by mugrean
4 comments posted 19yrs posted by mugrean

Priming MDF surfaces ( not cut edges )

Hello- I built soffits in my basement using MDF. All the cut edges of the MDF are either inside unexposed joints or are...
3 comments posted 19yrs
posted by kevharper
3 comments posted 19yrs posted by kevharper