Well to steer the discussion back to woodworking I have done some practice work with my Shaper Origin.
I am knee deep in a Murphy bed and tower cabinets build.
I build one of these right at 10 years ago and used the same supplier of Murphy bed hardware.
But this Murphy bed kit is a bit more fancy and adjustable. The other bed only required holes up to 1" in diameter to be drilled. Same with this one however there are extra parts that nees a 3/4" x 3.5" x 1/4 deep mortise that has 3/4" radius ends.
So drill two 3/4" holes and chisel chisel chisel, and cuss.
"OR"
Pull out the Origin and let it do all!
So no computer, no drawings. All necessary set up is done on the Origin screen.
Obviously I told it to drill a couple of holes a certain depth and used the cross hairs on the Origin screen while zoomed in, to match the cross hairs on the material.
Perfect, Except the object that needed to fit the 1' hole would not fit. Pulling our my calipers the object measured 1.008". I told Origin to make that existing hole .01" larger. No additional alignment to do this, Origin already knew what it had done and exactly where. The second pass and the part fit perfectly.