Still looking for some glue.. went in toolstation and they said they used to sell aquabord and the buyers used gluescrew or similar to put it up. Does this sound OK or should I use a neutral cure silicone? Silicone doesn't appear to have much strength anyway.
Aquabord again..
Apr 16, 2008
4 Replies
do you need strength or stickability ? High Modulus silicone is superb for sticking things in place ... it's not rigid, as a small amount of 'give' but sticks to just about anything.
I wish I knew, I just read the destructions and it said solvent free silicone spread on the wall and press the board on from the bottom to eliminate air bubbles. Two 310 ml tubes per board typical.
You can use dot and dab Dennis but use a waterproof tape on the joins if in a wet area.
It comes with corner cover pieces that are siliconed to the wall and then to the boards with a clip on cover strip on top. I hope they are water proof after that. 8-)
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required