I have a Delta TS350 table saw. My blade is at 45 degrees and I cannot return it to 90. The handwheel and attached shaft turn but the blade does not move. When I set the blade at 45 I probably used too much force to try to get it to turn just a little bit more. The problem seems to be in the area of the tilt mechanism. Any suggestions on how to correct the problem?
I have a Delta TS350 table saw. My blade is at 45 degrees and I cannot return i (2025 Update)
Sep 23, 2015
Last reply: 1 year ago
1 Replies
Realize that this is an old post, and I am not a registered member of this forum. But I have the exact same issue with my Delta TS350. If anyone can enlighten me or point me in the right direction, I'd be grateful. Thanks
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required