Latest threads in Power Toolsshow only best voted threads
| Subject | Author | Posted | Replies | |
|---|---|---|---|---|
|
|
Dremel tools - Older models...repairs...some can have rotation reversed...my experience.
I recently rebuilt my old Dremel rotary tool. It is a model 380-6 from the 80s. It had been sitting unused for years because the bearings had failed causing terrible noise and bad performance. Due to...
—
|
3 years ago
|
— | |
|
|
BATTERY
I need battery for my power devil PDD2148KKL
—
|
4 years ago
|
— | |
|
|
Wood Lathe
I have a Professional Woodworker bench top lathe V#3514, Stock number WL6/03028. Does anyone know where I can find a manual for it. I have been to the Manuals Library and the brand wasn't even there.
—
|
4 years ago
|
— | |
|
|
Leads to switch on ryobi table saw
I took out switch on ryobi table saw and didn't pay attention to which leads go to brass and silver blades. I have 2 white wires and 2 black ones
—
|
5 years ago
|
— | |
|
|
I borrowed an 8' Ryobi pole saw and the bar stud just spins around! help!!
Did I damage the plastic piece that holds the stud? I managed to take it out and found the replacement for 99 cents. I will get it in a week. Should I replace the hex nut too? Do I need to buy a new...
1
|
8 years ago
|
1 | |
|
|
Replacement parts (collets) for HF 91130 router
I need a 1/4" collet for this router. A 1/2' to 1/4' reducer would also work. My local store was little or no help.
—
|
8 years ago
|
— | |
|
|
My kc9036 came with a drill bit but i can't find any piece that will hold it?
No further details provided
—
|
8 years ago
|
— | |
|
|
i switch my electric mixer on the motor only humms doesnt turn drum i give the belt a spin and the mixer turns as it should
i switch my belle electric mixer on and the motor only hummss but will not turn drum, i give the belt a push then motor runs as it should mike
1
|
8 years ago
|
1 | |
|
|
I'm looking for replacement belts for work zone electric file 400W
No further details provided
—
|
8 years ago
|
— | |
|
|
why diamond is not suitable for grinding steel
No further details provided
1
|
8 years ago
|
1 | |
|
|
I am looking for drive belt ms-1634 model H-31A IT IS A STANLEY SERIAL # F-39791
No further details provided
—
|
8 years ago
|
— | |
|
|
poulan chainsaw compression
What is the compression specs on a Poulin P4018
—
|
8 years ago
|
— | |
|
|
What is the differnce between sawsall and reciprocating saw
No further details provided
1
|
8 years ago
|
1 | |
|
|
battery charging problems
Battery won't charge correctly, it keeps blinking red and green on the charger. Wondering what to do?
2
|
8 years ago
|
2 | |
|
|
jigsaw with very slow rpm startup and cheap
looking to get a cheap slow rpm startup jigsaw its not gonna be used for cutting just another project
—
|
8 years ago
|
— |