TABLE SAW JIG - To true up irregular stock

Feb 21, 2006 2 Replies
J

formatting link
Or, joiting on the table saw.


JOAT IThere is no vaccine against stupidity!



Vote
Twitter Facebook LinkedIn

  • BACKHOE

    http://www.metalwebnews.com/howto/backhoe/backhoe.html This one's metal,...

  • CAR STAND

    http://zhome.com/ZCMnL/PICS/jackUpCar/front_block.jpg If you need plans for...

  • PLAYHOUSE / DOLLHOUSE

    http://www.beforethearchitect.com/images-draftings/M09cs14.jpg Personally I...

N

JOAT, do you have any idea why the guide piece is smaller than the work piece? I would think you'd want the guide piece to extend beyond the irregular piece, so it's fully supported from beginning to end.

Thanks, Nathan

Vote
Twitter Facebook LinkedIn
M

|

formatting link
|| Or, joiting on the table saw.

And if you don't want nail holes in the jointed stock:

formatting link
will do the same job(s).

-- Morris Dovey DeSoto Solar DeSoto, Iowa USA

formatting link

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required