It is looking like it might be best to make a setup that holds the router above a table. That way I could just use stock Chamfer bits.
Thanks for all the input!
It is looking like it might be best to make a setup that holds the router above a table. That way I could just use stock Chamfer bits.
Thanks for all the input!
No.
Not true. I use a bearing guided chamfer bit all the time. It works great, and requires very little setup time. Without the bearing, I'd need to dick around with a fence.
Lookie here:
Sorry, I left off an anti-wrap bracket!
Here's the link:
Barry
that's a *bottom* bearing chamfer bit.
RIGHT YOU ARE!
For some reason, I was thinking of chamfer bits with NO bearing vs. the bottom bearing type.
Neeeeeeeeeeeeeeevvvermind!
Barry
HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.