remote control for 3 phase machine

Depends what you mean by "Remote Control".

Yes.

Make sure the radioactive stuff you are milling is all disposed of when going back in the room? Brian

Suitably rated Contactor relay assuming on/off.

Also assuming quality of question and the depth of detail, I strongly suggest this should be specified and physically tackled by someone competent.

No, but you can try addressing your enquiry to the Home Owner's Hub forum where they seem to specialise in such questions. You might, with a bit of luck, get an answer there.

Control of a three phase machine from a distance. i.e when you are not present at the controls.

Not rocket science!

Are you a knuckle dragging Brexit voter or similar?

AB

Same way as you control anything else from a distance. The local transducer/switch will have to be rated for the appropriate current, voltage and number of phases. The easiest way to do it also depends on what the distance is.

Spoken like a true Remoaning sociopath.

'Merely trying to assist someone with difficulty understanding the blindingly obvious.

A knuckle dragging Brexit voter might need a simpler explanation, maybe a few coloured pictures too.

It's all academic since anyone asking such a stupid nebulous question would have a great deal of difficulty plugging the machine into the

AB