Hi all
I am fitting a shower screen which is essentially a U shaped channel screwwd to the wall and a sheet of glass fitted in it.
The tiled wall unfortunately has a big bow in the middle resulting in top and bottom around 7mm from the tiles.
I had a few thoughts but none ideal
- Angle grind a slot in the middle tiles to slot the frame in
- Angle grind the frame to remove some in the middle to compensate
- Fit as is and pack then stick a load of silicone to cover it
Anyone have any cunning ideas ?
Also the instructions say to only silicone the outside edge of the glass and in bold expressly says not to silicone the inside edge. Any idea why?
Thanks
Lee.