good afternoon folks,i need to buy a circular saw blade,30mmx185/190mm for fine finish cutting in mdf and ply,can you advise what i should be looking for teeth wise,kind regards and thanks,Bob
circular saw blade
Feb 12, 2010
4 Replies
I would have thought that something like this would probably do the job:
formatting link
Roger Mills wibbled on Friday 12 February 2010 17:30
course, it does actually cut quite nicely with minimal splintering (virtually none if you're lucky).
Go for minimum 40 teeth. Best place to buy IME
formatting link
if it's MDF then you need TCT with minimum offset.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required