Home Repair

76594 Threads Posts
to

Replacing hose bib - How tight is tight?

I recently replaced a hose bib valve for my washing machine. Rather then screw around with corroding stems and washers...
4 comments posted 20yrs
posted by jay
4 comments posted 20yrs posted by jay

GE Washing Machine -- Water Outside of the Tub

Hi, I have a GE washing machine. I've recently noticed that when the waching machine has completed it's job and...
2 comments posted 20yrs
posted by mgordon
2 comments posted 20yrs posted by mgordon

Wiring help - Outet replacement

Hi - I am in the process of replacing seveal outlets in my home. I have made it successfully through 5, but the 6th is...
2 comments posted 20yrs
posted by jhaverson
2 comments posted 20yrs posted by jhaverson

Clearcoat aluminum wheels?

I've got some new wheels for my car. They're polished aluminum. Before I mount them on my car I'd like to p...
8 comments posted 20yrs
posted by dont.spam
8 comments posted 20yrs posted by dont.spam

Lubricant leaking out of agitator shaft

I'm getting lubricant leaking out of the base of the agitator shaft on an old Hotpoint washer. I assume a seal has b...
2 comments posted 20yrs
posted by docsavage20
2 comments posted 20yrs posted by docsavage20

Replacing a hot water heater. Efficiency?

Hello, I need to replace a hot water heater whose tank has cracked. Any recommendations? I'm leaning towards just a...
41 comments posted 20yrs
posted by JayPique
41 comments posted 20yrs posted by JayPique

radiator covers?

Where might I find radiator covers for the old cast iron radiators?
1 comments posted 20yrs
posted by vze2zg25
1 comments posted 20yrs posted by vze2zg25

Murray Lawn tractor wont go into gear

It started when I went to cut the grass. I put it into gear and started to roll, and low and behold one of the tires wa...
1 comments posted 20yrs
posted by me
1 comments posted 20yrs posted by me

getting rid of rats

I recently have done battle with rats in my garage. Since usenet was a big help to me, I thought I'd summarize what...
71 comments posted 20yrs
posted by bbmwr90s01
71 comments posted 20yrs posted by bbmwr90s01

Northstar generator problems - SOLVED

Hello: I found the solution to a previous thread I started about problems with my Northstar 8000W generator and wanted...
0 comments posted 20yrs
posted by chris
0 comments posted 20yrs posted by chris

Making screws easier to remove next time!

Pre. S. Is there such a thing as tempered aluminum? So I got all the screws that I needed to out of the '69 Honda t...
18 comments posted 20yrs
posted by NOPSAMmm2005
18 comments posted 20yrs posted by NOPSAMmm2005

enlarge hole in bottom of ceramic pot

I just purchased a large ceramic pot which has a 1/4 inch hole at the bottom. I need to fit the pot over a 1 & 3/4 inch...
13 comments posted 20yrs
posted by aaronep
13 comments posted 20yrs posted by aaronep

What to do with these stairs?

Hi, I think I have unsual stairs in that each tread does not extend "inward" past the one above, resulting in something...
3 comments posted 20yrs
posted by aaronfude
3 comments posted 20yrs posted by aaronfude