Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

Anyone using CNC? I Need Info

I've got a number of outlets for press releases pointed directly at the production and/or manufacturing industry. Howev...
0 comments posted 21yrs
posted by bob
0 comments posted 21yrs posted by bob

I actually used a plane for the first time!

I have bought a few planes at garage sales, tuned and sharpened them, and played with them; but never actually used one...
3 comments posted 21yrs
posted by Toller
3 comments posted 21yrs posted by Toller

Grizzly 1023SL router table

Hi all, I just posted some pics in ABPW which shows how I added a router table to the right side of the Griz 1023SL TS w...
3 comments posted 21yrs
posted by loutent
3 comments posted 21yrs posted by loutent

loctite power grab

Instant bond saw on TV: hammer to ceiling and brick to vertical plywood. Does this mean I could put away my hammer and n...
2 comments posted 21yrs
posted by Fred
2 comments posted 21yrs posted by Fred

Current Project (Minor But Fun)

And, I still at'nt dead. Heh heh. I've long had a liking for single-shot rifles. But, finances, rather lack thereof, fo...
7 comments posted 21yrs
posted by Jakofalltrades
7 comments posted 21yrs posted by Jakofalltrades

Teflon Coated TS Blade Slipping

I bought one of those red Freud blades that's teflon coated and I'm now having trouble figuring out how to snug it tigh...
21 comments posted 21yrs
posted by JayPique
21 comments posted 21yrs posted by JayPique

Question on Wood to UHDP Friction Reduction

I built a small ripping sled from baltic birtch ply. It slips over my rip fence (Jet Xacta type) which has UHDP panels...
3 comments posted 21yrs
posted by xleanone
3 comments posted 21yrs posted by xleanone

can I cut ipe with a steel bandsaw blade?

I'm planning a small deck project and I think I may need to cut notches at the ends of some 4 x 4 ipe posts. (By "notch...
7 comments posted 21yrs
posted by adrian
7 comments posted 21yrs posted by adrian

Table saw rust removal

I read a few places that I need to sand with fine grit sandpaper and then use wax to protect the surface. Problem is th...
20 comments posted 21yrs
posted by dvdmtl
20 comments posted 21yrs posted by dvdmtl

Stain for the "Rustic Pine" look?

I'm building a shed with pine siding, what should I look for in a long lasting durable stain or combination stain/sealer...
7 comments posted 21yrs
posted by nospam
7 comments posted 21yrs posted by nospam

panasonic 15.6V drill

I am about to buy this cordliss drill, but was wondering if anyone has any experience/opinions on how much of a differe...
10 comments posted 21yrs
posted by chester
10 comments posted 21yrs posted by chester

Connecting new wood floor to existing wood floor

I am installing an oak tounge and groove floor in our downstairs den. The foyer leading into the den already has oak fl...
4 comments posted 21yrs
posted by bill_brennum
4 comments posted 21yrs posted by bill_brennum

Hardwood/exotic supplier in Raleigh, NC?

Hi all, I'm looking for an alternate supplier of hardwoods and exotics in or close to Raleigh, NC. For small projects I...
12 comments posted 21yrs
posted by rgp
12 comments posted 21yrs posted by rgp