For Sale PM64A Contractor Saw & Accessories - $900
PM64A Saw w/ 30" Accu-Fence and Blade. ($899 purchase price in 2002)
Mobile Base – Custom HTC. ($95)
PALS Trunion Alignment Gizmo. ($20)
Machined Steel Pulleys and Link Belt. ($50)
(3) new and (2) already cut Zero-Clearance Insert Blanks. (@ $20 = $100)
Blade Stiffeners – (2) 3" by CMT ($25)
Large Radius Dust Collection Elbow - ($10)
Total Above Cost = $1199.
Shop Made- Knee Kick Off Safety Paddle Switch ($ ?)
Shop Made- Motor Enclosure (Dust Control) and Outfeed Table ($ ?)
Extra Accu-Fence ($ ?)
Asking $900. Photos Available.
Located in Maryland suburbs of Washington D.C.
Will not Ship.
Contact Ken: firstname.lastname@example.org
I realize I am not giving anything away at this price, but this is a must see
if you are looking for a high quality contractor saw. It has all the typical
upgrades – mobile base, machined pulleys, link belt, PALS- and it is tuned
up and dialed in to the third decimal place and ready to go.
It is 2 yrs old. I have $1200 into it, not counting the shop made safety
switch and dust enclosure/outfeed table (which came out great) and the
extra Accu-Square Fence. The Dust enclosure totally seals off the rear of
the saw while still allowing full motor tilt. (I even matched the Powermatic
gold paint color perfectly.) Dust collection through bottom tube is very
I am inheriting a cabinet saw from my father-in-law; otherwise I would
not be thinking about selling this PM64A which I only just got, it seems.
It is a great saw and I would keep it if I had the room. I have jpgs of it
which I can email to serious inquiries.