Kew hobby pressure washer

It is not normal for a pressure washer to make generator noise without any water coming out. It is possible that there is an issue with the pump or the water supply to the unit. As for the pressure loss after 20 minutes, it could be caused by a clogged nozzle or a malfunctioning pump.

Regarding the on button being difficult to push, it could be an issue with the switch or a problem with the electrical connection. It is best to check for any visible damage or debris around the switch and consult the manufacturer or a professional if the problem persists.

As a DIYer, you can try the following troubleshooting steps to fix the issue with your pressure washer:

Check the water supply: Make sure the water supply to the unit is turned on and that there is enough water pressure.

Clear an y blockages: Check the nozzle for any blockages and clear them if necessary.

Check the pump: Inspect the pump for any signs of damage or wear. If the pump is damaged, it may need to be replaced.

Check the hoses: Make sure the hoses are properly connected and not damaged or kinked.

Check the power supply: Ensure that the unit is plugged in and that the outlet is functioning properly.

Check the switch: Make sure the switch is not damaged or loose. If it is, try cleaning it or replacing it.

If these troubleshooting steps do not resolve the issue, it may be best to consult the manufacturer or a professional for further assistance.

One thing people need to check is the age of the message they are replying to. Brian

Brian Gaff snipped-for-privacy@gmail.com wrote

That one wasnt too bad, just 10 months old.

who's the wit calling themselves hoh advisor?

lack of water or blocked hose will do that

it could be caused by almost anything, those plus debris in the supply, kinked hose, etc

yes, check the completely obvious first

lousy diy advice. If the switch won't switch on you pretty much know where the issue is.

The op has come to a diy group to ask how to fix their appliance. Do you think they need to be told to plug it in first?

Better bet is to ask a group of diyers how to fix it, which the op has already done.

If the switch won't operate normally the op should know what's wrong. If not, don't do any diy ever.

And there is the small matter of the date.