Humax HDR Fox T2 playing up

Sep 29, 2026 Last reply: 1 month ago 11 Replies
Saved reading
Jump to replies (11)

Our old Humax doesn’t owe us anything but it’s having boot up issues. When powered up there’s no spinny noises from the hard drive and it goes through several boot up cycles before the drive eventually boots up. From then on, it works perfectly.



What’s the likeliest cause? It’s had a new hard drive or two in its long life but nothing else.



Tim



dying hard drive

-- “It is not the truth of Marxism that explains the willingness of intellectuals to believe it, but the power that it confers on intellectuals, in their attempts to control the world. And since...it is futile to reason someone out of a thing that he was not reasoned into, we can conclude that Marxism owes its remarkable power to survive every criticism to the fact that it is not a truth-directed but a power-directed system of thought.” Sir Roger Scruton

Guess, failing electrolytic capacitors in the power supply

I have been having posting issues; let's see if this gets through.

This is a very common fault. It's an electrolytic capacitor (4.7uF) on the main board, bear centre front. Fixed mine with no trouble (easier to do with a wire ended replacement, there's plenty of room).

Full details on hummy.tv, which is unfortunately down right now.

formatting link
Failing that, I have a spare in storage, and I'm visiting the unit next week. I can bring it back and take pictures.

That would be most helpful. Thanks. I’ll pull the lid on mine and have a poke around for likely candidates.

Tim

Oh bollocky bolocks. I think I’ve f*cked it up.

I used my finest tipped soldering iron and gently eased up the capacitor after heating the accessible bits of the pads but the solder pads on the PCB have come off. :-(

formatting link
New motherboard time or is this rescueable?

Tim

Look up Dell parts people laptop repairs on you tube. Reworking this is possible and easier with a hot air station than a soldering iron, but it is possible

He uses sticky backed copper foil, teensy wires and UV hardening 'soldermask;

Alternatively run wires from the capacitor to where it was originally going and secure with hotsnot or epoxy

There may be another issue. If this is a mulitlayer PCB with connections through the layers the damage might not be easily repairable. Can you see if it's multilayer from the side of the PCB? Try an internet search on: multilayer pcb repair

Try and see where those pads go to. Might have to take the board out. There ought to be another point where you can connect the capacitor. The partial circuit diagram on the website may help. It's not a high frequemcy connection, so even if you have to run a piece of wire under the board, it should work.

Well after f*ckingup the old Humax a second-hand replacement from eBay has solved the problem.

A cop out I know but at £31 not a terribly expensive cop out.

At least you know how to fix it next time.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required