In operation it is making a hooting noise. This seems to be occurring when the main pump is running rather than the drain pump. Also there is an under tray that is collecting small amounts of water but this is enough to activate the drain pump constantly. Finally, the rcd tripped recently although I cannot be sure that was down to the dishwasher.
Any ideas on the problem here please?
Thanks
Phil
Didn't find your answer? Ask the community — no account required.
T
thescullster
Thanks Roger
I'll have a look there first.
Phil
R
Roger Mills
My first guess would be a seal failure in the main pump, allowing water to get into its bearings - and possibly its electrics. That could explain all of your symptoms.
L
Lee
On most recent-ish Bosch models the o-ring between the washing area and the pump fails. It's so common there are replacement kits all over Ebay and the usual suspects. The O-ring is available separately, but Bosch suggest changing the entire pump housing - well they would :)
{A very dirty (greasy) door seal can also allow water into the base - in fact it is designed to do so, as there is a drainage channel for the purpose. Better than letting it leak over the floor I guess.}
In fact we need to do ours*, but it's a bit of a pain to get access to do it properly and we discovered it's pretty much OK if we only do "quick Washes". So the TUIT is delayed :)
*ours is an "aqua stop" model, so it just shuts of the water and sits and sulks with an error code when it detects water in the bottom of it. Then it's a game of drying it out with a hair dryer before the code will reset :)
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required
Report Content
You are reporting this content to the moderators. They will look at it
ASAP.