convert pressure washer to waterjet cutter
convert pressure washer to waterjet cutter
May 30, 2017
3 Replies
Follow replies to this discussion?
Information here may be outdated?
Made me cringe seeing his fingers so close to the jet.
OK, it's only 3000 psi or so, which is fairly low pressure for a water jet cutter. But still, you can get nasty injuries from hydraulic fluid at those pressures.
He's normally a sensible chap, but it wouldn't have taken much of a slip to lose a finger ...
Its an abrasive stream so it will do a lot more damage than plain water.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required