Hi,
I have little understanding of what happens in the drying stage; is it simply the the hot water sprayed on the plates that does the drying, or is the chamber heated please?
Either way, it is not drying properly (even on extra dry time). Is this a DIY job please? If so, what is replaced and how do you get it out? I have had the top and sides off, and the bottom is completely encased. It is saying 'Don't touch me!!!' lol.
Any help please?
Thanks,
Paul.
Hi
There is a heating element in the floor of the machine.
If you visit this address:-
The most likely problem is that the heating element has gone open circuit although there could be other explanations.
Steve
You need to click on Service, then QuickFinder by the way.
Steve
Thanks very much for your quick reply Steve. I had two problems, the site appears to require a login :(, and I could find no number whatsover on the door or its surround funnily enough. That wouldn;t have been such a big problem, as I could navigate via
Thanks,
Paul.
The number *is* there, just don't expect a label. It's probably engraved/stamped into the metal - try the top edge of the door, inside.
useful. Still not clear what the problem is :(
Regards,
Paul.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required