Home Repair

76592 Threads Posts
to

Not your run of the mill Frozen Pipes problem

Last week woke up and the downstairs main heating zone was not heating. A second zone feading just 1 room was working a...
3 comments posted 19yrs
posted by scousa
3 comments posted 19yrs posted by scousa

GB instrument, circuit breaker finder question

Has anyone here ever used a an Electronic Circuit Breaker finder? More specifically a GB instruments CB locator. This i...
4 comments posted 19yrs
posted by claudec
4 comments posted 19yrs posted by claudec

Amana side by side frig problem

I have the frig set on the lowest setting (#1) and on the bottom 3 shelves everything freezes. There is no problems wit...
5 comments posted 19yrs
posted by will
5 comments posted 19yrs posted by will

New AC

I live in central Texas. What is an approximate cost to replace a central heat and AC? We are looking at an American Sta...
4 comments posted 19yrs
posted by jlemmons
4 comments posted 19yrs posted by jlemmons

Tiling over a slightly uneven concrete slab

Im in the process of gutting a tiny half bath and Im about to tile the floor. After pulling up the original flooring an...
9 comments posted 19yrs
posted by rklotz
9 comments posted 19yrs posted by rklotz

"Variable heat" electric range available anywhere?

Does anyone manufacture a "variable heat" electric range, where when you select the heat setting, it would have a const...
46 comments posted 19yrs
posted by bill190nospam
46 comments posted 19yrs posted by bill190nospam

hot water suddenly rusty

Gas-fired HW heater, 7 yrs old. Yesterday, our hot water suddenly became quite rusty. I've filled and drained the t...
8 comments posted 19yrs
posted by gbeccles
8 comments posted 19yrs posted by gbeccles

hardiplank vs cedar

i need to replace quite a bit of wood trim on my house, it is painted cedar now. eave trim will be cedar for continuity...
4 comments posted 19yrs
posted by dgibsonieainc
4 comments posted 19yrs posted by dgibsonieainc

Question - electrical short

I did a stupid thing - but I am curious. Someone lent me his air compressor on which he had a 3-prong male plug. He had...
23 comments posted 19yrs
posted by Wilson
23 comments posted 19yrs posted by Wilson

Tile on floor before cement is set/hardened OK?

I want to build 3" high cement base for my cabinet and wish to tile it as well. To save time can I put the tiles on the...
6 comments posted 19yrs
posted by iissmm
6 comments posted 19yrs posted by iissmm

Energy Saving Bulb lifetimes

After one year, a 40 Watt flourecent energy bulb went bad and would not fully light up. I think the manufacturer specif...
23 comments posted 19yrs
posted by sherwindu
23 comments posted 19yrs posted by sherwindu

GeneralAire Humidifier Install Question

I installed a General Aire Model 1042L Humidifier 4 years ago with the bypass 6 in duct installed in the return air duc...
2 comments posted 19yrs
posted by malam
2 comments posted 19yrs posted by malam

sheetrock over plaster?

I have a 1950's brick home in Virginia with true plaster interior walls and it's time to repaint a stairway wal...
11 comments posted 19yrs
posted by milo_dhuey
11 comments posted 19yrs posted by milo_dhuey