Home Repair

76591 Threads Posts
to

Kenmore washer

My ancient washer has a problem. Except for this, it works fine. When it goes into spin cycle, the tub spins, but it wo...
3 comments posted 19yrs
posted by beggar
3 comments posted 19yrs posted by beggar

septic tank treatment

I have been in the septic system industry for 22 years and used a lot of different kinds of treatments. The best treatm...
5 comments posted 19yrs
posted by soilman1234
5 comments posted 19yrs posted by soilman1234

Septic tank roots

Help! I have a problem with roots growing in my septic tank. What do you recommend to kill them and prevent them from co...
11 comments posted 19yrs
posted by donovanharper
11 comments posted 19yrs posted by donovanharper

OT - How to sell a car?

Oddly, there are no good usergroups I know of for a question like this. ahr seems as good as any place. I have my car f...
14 comments posted 19yrs
posted by Toller
14 comments posted 19yrs posted by Toller

Drywall Self Adhesive Tape?

Is there Drywall self adhesive tape to put on drywall edges and seams. The drywall instructions on the web all say to a...
5 comments posted 19yrs
posted by albert
5 comments posted 19yrs posted by albert

Rotten Siding - Part 2

OK guys: If you remember... I was repairing my siding that is rotten on the bottom due to incorrect installation. The f...
4 comments posted 19yrs
posted by jthread
4 comments posted 19yrs posted by jthread

Radon fan recommendation

I'm installing a sub slab depressurization system and am looking for a recommendation on a good quality radon fan....
0 comments posted 19yrs
posted by mark.leininger
0 comments posted 19yrs posted by mark.leininger

Roofing and roof jacks

Ok, so when using roof jacks on a roofing project, what do you do with the raised nails that were used to hold the roof...
5 comments posted 19yrs
posted by meyousikmann
5 comments posted 19yrs posted by meyousikmann

John Deere Question

I had this buried in another post. It probably should've been separated. Does anyone have first hand experience wit...
3 comments posted 19yrs
posted by DrDoom
3 comments posted 19yrs posted by DrDoom

Recommendation for good quality Radon fan

I'm installing a radon sub slab depressurization system. There are many radon fans on the market, does anyone have...
0 comments posted 19yrs
posted by mark.leininger
0 comments posted 19yrs posted by mark.leininger

Toilet bowl full of water

I have 2 toilets where the bowls are 3/4 full of water. When flushing they either flush very very slowly or don't f...
17 comments posted 19yrs
posted by NutsRus
17 comments posted 19yrs posted by NutsRus

Gas oven temperature control problem

I'm not really sure this is thermostat problem. This range is O'Keefe and Merritt and is probably from the 50&#...
4 comments posted 19yrs
posted by man
4 comments posted 19yrs posted by man

Metal Buildings, what's your experience?

I want to get a metal building. I called contractors. For a 1500 sf building, they want $55,000 to $65,000 for a total...
22 comments posted 19yrs
posted by SurDO2Diver
22 comments posted 19yrs posted by SurDO2Diver

Installing 32" prehung entrance door

A couple major issues: The wall is about an inch off plumb from the bottom of the door from to the top (81.5 inches) Th...
10 comments posted 19yrs
posted by meat
10 comments posted 19yrs posted by meat

Whole-House Gable Exhaust Fan Questions

Hello: Would like to add a whole-house attic exhaust fan to a presently louvred gable, where there is presently the typ...
1 comments posted 19yrs
posted by rgsros
1 comments posted 19yrs posted by rgsros