Home Repair

76587 Threads Posts
to

Briggs and Stratton Electronic Ignition Retrofit

Hello: I hope to convert the ignition on a Briggs and Stratton engine from points to Magnetron (electronic). The instru...
3 comments posted 18yrs
posted by g_czplzn
3 comments posted 18yrs posted by g_czplzn

Smoke Detector Timing

I have First Alert smoke detectors located throughout my house (each bedroom, main hallways, and two non-bedrooms.) The...
13 comments posted 18yrs
posted by cuhulain_-98
13 comments posted 18yrs posted by cuhulain_-98

Ariens Snow Blower Belt

I have an old Ariens snowblower, Model # 92208 (5HP 20"). The belt that drives the blower has broken. Does anyone know...
12 comments posted 18yrs
posted by jjmjij
12 comments posted 18yrs posted by jjmjij

Damn, it's cold

Got down to 38F last night in Houston. Had to put on all the clothes I owned. Even had to get another blanket. From the...
80 comments posted 18yrs
posted by heybub
80 comments posted 18yrs posted by heybub

Can't believe this...

just finished replacing my kitchen sink yesterday... had to make a new drain pipe for it, and also do some minor repair...
19 comments posted 18yrs
posted by njnagel
19 comments posted 18yrs posted by njnagel

Fiberglass Insert and Plumbing Access

Hello All, While trying to change a shower head in a Aquaglass tub/shower/spa insert, it seems I managed to break the p...
5 comments posted 18yrs
posted by rmcghee
5 comments posted 18yrs posted by rmcghee

ot a bit, need new tire suggestions

I need new tires on a 2007 half ton (2 wheel drive) Chevy Silverado pickup. The originals are General (Ugh) and have no...
14 comments posted 18yrs
posted by bobwhite
14 comments posted 18yrs posted by bobwhite

Is it safe to use a load miser???

Hi, Since I only have one 220V entry, I would like to plug a clothes dryer on my oven plug using a load miser 15A/40A....
7 comments posted 18yrs
posted by mtl343
7 comments posted 18yrs posted by mtl343

Laying new cable for electric and Telephone / TV

I am relaying cable network for my complete house which is G+2. All lines including electrical, Telephone ( PBX), Cable...
2 comments posted 18yrs
posted by brtodi
2 comments posted 18yrs posted by brtodi

Raising the bathroom

Greetings.....I have a bathrom that slopes down over a inch or so at one end, the foundation has sunk that much over th...
7 comments posted 18yrs
posted by Christopher_F
7 comments posted 18yrs posted by Christopher_F

Forced hot air caulk?

Hi all, I saw a DIY show up here in Canadia (eh) where the HVAC sub was gunning a caulk around the plenum joints and the...
6 comments posted 18yrs
posted by a
6 comments posted 18yrs posted by a

Pro or Con Infrared Sauna

Hi, Anyone using it? Good, bad? Worth it, not worth it? Thinking about one for family use.
0 comments posted 18yrs
posted by dragon40
0 comments posted 18yrs posted by dragon40

electrical protective plate code

Someone at Home Depot was telling me that there is a new regulation in Ontario that the electrical code that says that...
2 comments posted 18yrs
posted by carcrash1
2 comments posted 18yrs posted by carcrash1

old 3 control of shower

I have a tub that also has a shower that contains the old 3 knobs for hot, cold and diverter. Its at shoulder level and...
2 comments posted 18yrs
posted by harri85274
2 comments posted 18yrs posted by harri85274