A quick guide to building a small ground-level base for beginners

Nov 08, 2026 Last reply: 6 days ago 4 Replies
Saved reading
Jump to replies (4)

After doing three of these little platforms now, I figured I'd share the stuff I wish someone had told me before my first wobbly attempt. Sloped ground looks intimidating but it's honestly the easiest part. Set your highest block first, get it level with a paver underneath it, then work outward from that corner checking level as you go. The blocks sit proud of the ground in the low spots and that's fine, that's the whole point of them.



Dig a shallow flat spot for each paver and tamp it down. Don't skip the tamping, that's what stops the whole thing from settling unevenly after the first good rain. If a block ends up higher than you need, bury it a bit rather than chipping away at the soil under the paver, you'll chase level forever doing that. For the frame itself, hang your joists properly instead of toe-nailing them, and throw in blocking down the middle row. It kills the bounce when you walk across it. I also like a corner bracket in each corner just for peace of mind.



And yes, once it's done you have to do the shake test and say it out loud. Tradition.


I had a similar expirience building the deck on a slight incline, but I found the spacing of the joists really determined the quality of the finished walk. I usally run 16 inches on center, and if you space them too wide, especally with a thick plank like 5/4, you can really feel the flex when you step on it. It makes the whole thing feel flimsy. For the blocks, I always prefer using the larger ones, like 6-inch high, because when the ground shifts a tiny bit over time, it takes a lot less effort to just nudge the whole block up on the concrete than trying to find a tiny sliver of space to push into the dirt under it. I've finished three decks now and the consistency is huge. I also made sure that my ledger attachment, where the deck meets the house, was flush and secured with lag screws. Even if the rest of the frame is rock solid, a loose attachment to the house is just waiting for a high wind to pull it apart.

The tamping advice is spot on, I learned that the hard way. Skipped it on my first platform and one corner sank maybe half an inch after a wet spring, had to shim the block back up. On the second one I put a couple inches of compacted gravel under each paver instead of just dirt and it's stayed dead level for two years now. Bonus is the gravel drains so the paver doesn't sit in a puddle every time it rains. Also fully on board with the shake test, my neighbors probably think I'm weird but the wobble check is non negotiable.

Ha, the shake test, my old crew called that the two-step. You stand on it, bounce twice, and if nothing rattles you tip your coffee at it. Anyhow, one thing I'd add for the low spots: back in the day we just set blocks on flat rocks we dug out of the yard, and half those decks are still standing at my old neighbor's place. Your paver method is cleaner though. I also stopped burying blocks years ago, keep them proud like you said, because a buried block is a block you can't fix when frost heaves it. How far apart did you space your blocks along the beam runs?

Update: tried the gravel bed trick under the pavers on the one I just built. Dug the flat spots a touch deeper and packed in a couple inches before setting them. Felt way more solid tamping onto gravel than dirt, so we'll see how it handles the winter. Question though, on the joist spacing comment, does 16 on center matter as much if you're running the boards diagonal?

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required