Woodworking Forum

  1. Home
  2. Woodworking Forum
51625 Threads Posts
to

Worth reading in Woodworking Forum

Anyone Have a Steel City 17" Drill Press?

...Looking for some detailed measurements based on a PDF I can send you. This is a 6" stroke drill press generally sold...
5 comments posted 16yrs
posted by autodrill
5 comments posted 16yrs posted by autodrill

OT:2009

Lets drink to ?09 with a good belt of wine (though whiskey may well be more fitting!) The recession was hairy, The swin...
1 comments posted 16yrs
posted by markem618
1 comments posted 16yrs posted by markem618

O/T: Exercise for people over 45

Enjoy Lew --------------------------------------------- Begin by standing on a comfortable surface, where you have plen...
4 comments posted 16yrs
posted by sails.man2
4 comments posted 16yrs posted by sails.man2

Ping: Robatoy

Will you close the door up there, it's getting cold down here, TIA :). basilisk
16 comments posted 16yrs
posted by basilisk
16 comments posted 16yrs posted by basilisk

OT: too funny

Dunno when I'll get any from the missus again, but this was just too funny... Flipping channels and stumbled across "Me...
2 comments posted 16yrs
posted by dave
2 comments posted 16yrs posted by dave

Workshop Heat - Natural Gas

Yeah, it is cold is SE Kansas. The kerosene heater + help from an electric cube heater does a pretty good job but looki...
18 comments posted 16yrs
posted by rnrbrogan
18 comments posted 16yrs posted by rnrbrogan

Brrr, It's cold in the woodshop!

In spite of the the wicked cold temperatures today, I still managed to get a little woodwerk'en done. Had my propane hea...
8 comments posted 16yrs
posted by bgrella
8 comments posted 16yrs posted by bgrella

Sketchup Tool Bar Restore

As many of you Sketchup users are aware the tool bars do not lock in place. If you resize the screen the tool bars move...
0 comments posted 16yrs
posted by lcb11211
0 comments posted 16yrs posted by lcb11211

old lathe ID help

inherited an old lathe, and i know little about them. looks pretty simple, but no plate or label anywhere. the lathe pu...
8 comments posted 16yrs
posted by sorrybutnospam
8 comments posted 16yrs posted by sorrybutnospam

Walking Challenge

Well I can't keep up with Marv yet, but I did walk 1.9-2 miles today on trail. Sure is easier on the eliptical trainer,...
12 comments posted 16yrs
posted by mikemcig-free
12 comments posted 16yrs posted by mikemcig-free

O/T: CNN

Think back to the wild fires this fall here in SoCal. Lew ----------------------------------------------------- CNN His...
0 comments posted 16yrs
posted by sails.man2
0 comments posted 16yrs posted by sails.man2

Paint stick back scratcher

Use a long paint stick. Mark two lines, one 1/4 inch from the end and the other 1/2 inch from the end.. Then, using a b...
22 comments posted 16yrs
posted by thenantz
22 comments posted 16yrs posted by thenantz

Dovetail saws

I have a cabinet to make with a couple of drawers. I'm considering hand cutting dovetails for the drawers and for top r...
17 comments posted 16yrs
posted by pknw29683
17 comments posted 16yrs posted by pknw29683