Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

Face Nail Engineered Hardwood question

Hi, I'm starting to lay down 3/8 inch engineered hardwood (3 inch wide plank) onto a 1 inch underlayment. Instructions...
6 comments posted 22yrs
posted by ksanny
6 comments posted 22yrs posted by ksanny

Unisaw dust collector hood

Did anyone get a dust collector hood/attachment with their new Unisaw circa 2002? just received my Woodsucker dust coll...
2 comments posted 22yrs
posted by br
2 comments posted 22yrs posted by br

Gloat??

Went to HD this afternoon to get some hooks to hang some plants. Stopped by tool corral (as usual) and ran into a gent...
3 comments posted 22yrs
posted by wmkuhn
3 comments posted 22yrs posted by wmkuhn

hand planing a panel flat

hi, I have 3 boards that are 1x4 maple to edge glue together into one table top board. Does each board get hand planed...
5 comments posted 22yrs
posted by dimit94844
5 comments posted 22yrs posted by dimit94844

Freud customer service

I recently had a Freud 1/4" straight cutting bit (smallest of the undersized plywood bit set) break apart in use while...
1 comments posted 22yrs
posted by walshsw
1 comments posted 22yrs posted by walshsw

"Screw it!"

Don't get excited, that's just what's on the little sticker, along with a logo, in every box of GRK plastic decking scr...
5 comments posted 22yrs
posted by bub209
5 comments posted 22yrs posted by bub209

a strong patch for an irregular hole?

That trumpet case again... The latch holes were routed out with rounds on either end. Hard to match that. So I decided...
4 comments posted 22yrs
posted by dmmcintyr
4 comments posted 22yrs posted by dmmcintyr

OOPS! Shouldda used a magnet.

I was looking for something thin, reasonably durable and attractive to cover some ugliness where I am filling in holes...
0 comments posted 22yrs
posted by dmmcintyr
0 comments posted 22yrs posted by dmmcintyr

Timber Frame or Post & Beam Shed Plans

I've googled, and really only come up with one set of plans. I'm leaning towards drawing up my own, as I'd like to inco...
5 comments posted 22yrs
posted by JayPique
5 comments posted 22yrs posted by JayPique

Finishing Q

I'm making a doll cradle for my daughter and debating the type of finish to use. I'm trying to decide between tung oil...
2 comments posted 22yrs
posted by tomwojeck
2 comments posted 22yrs posted by tomwojeck

moldy apple wood, usable?

I'm trying to dry a small amount of apple wood. I stacked and stickered it outside (following the advice in Understandi...
3 comments posted 22yrs
posted by adrian
3 comments posted 22yrs posted by adrian