Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

Automatic wood shaping??

I have a lure-making business and am looking for someone that can cut out 7 inch lures from hard maple for me. I unders...
6 comments posted 20yrs
posted by countinsheep
6 comments posted 20yrs posted by countinsheep

New cedar fence

Hi - making a new veggie garden fence for my DW. She's been putting up with me for all these years - she deserves a nic...
1 comments posted 20yrs
posted by tom
1 comments posted 20yrs posted by tom

While we're on the subject of customer service . . .

I own a Dremel 400 Series XPR Rotary Tool and I was looking at getting their small router table accessory for it. Unfor...
4 comments posted 20yrs
posted by nospamplease
4 comments posted 20yrs posted by nospamplease

how do I clamp this?

Hello, I'm building a candlestick table, and I can't figure out how to glue and clamp the legs to the center column. An...
10 comments posted 20yrs
posted by cblood59
10 comments posted 20yrs posted by cblood59

Damn MDF Dust

My son-in-law called me last night to come over today & cut 15 shts of MDF into 7" strips. My SWMBO hates this stuff be...
0 comments posted 20yrs
posted by Tom
0 comments posted 20yrs posted by Tom

more great customer service - Infinity Tool

I know there have been a few discussions of customer service recently - reports of good examples as well as debates ove...
1 comments posted 20yrs
posted by andynewhouse
1 comments posted 20yrs posted by andynewhouse

SHOPFOX DEALER PLANER QUESTION

I just got a lesson today from a Shopfox dealer. I had checking around to buy a 15 inch planer. I looked at Jet, Delta,...
32 comments posted 20yrs
posted by bill8vp
32 comments posted 20yrs posted by bill8vp

Finish Nailer, which?

Probably going to open a can of worms here but here goes. If you were going to own one finish nailer (under $200) for "...
60 comments posted 20yrs
posted by robmills
60 comments posted 20yrs posted by robmills

FS - Shopsmith, Mark V

Planning on starting to get this out on some of the 'net sites next week, but figure I'm here now and since this is a w...
0 comments posted 20yrs
posted by no-one
0 comments posted 20yrs posted by no-one

Mortise & Tennon jig info wanted

I was watching the British Woodshop on the Woodworking Channel (It's a great site to watch) and the fellow was using th...
20 comments posted 20yrs
posted by tom
20 comments posted 20yrs posted by tom

What is better tennon or dowel?

I have alway prefered a tennon to dowels and biscuits as joinery. So what i would like to know is what is better a tenn...
3 comments posted 20yrs
posted by bronwyn.bronwyn
3 comments posted 20yrs posted by bronwyn.bronwyn

Display Box Hinge Needed

I"ve looked locally and on the net,Rockler,woodcraft...etc and can not seem to find a hinge like this...that is very ch...
2 comments posted 20yrs
posted by woodgirl68
2 comments posted 20yrs posted by woodgirl68

Cutting knife slot in piece of wood

Hello, I have a 2.5 inch by 18 inch by 7/8 inch thick piece of wood. I was hoping to cut a slot down the middle 12 inch...
18 comments posted 20yrs
posted by lccronin
18 comments posted 20yrs posted by lccronin