Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

Clear Douglas Fir ???

Built some outside flower planter boxes 15 years ago out of Clear Douglas Fir and time and weather have finally taken t...
7 comments posted 20yrs
posted by dennxx2789
7 comments posted 20yrs posted by dennxx2789

rail and stile vs cope and stick

Is a "rail and stile" router bit set the same as a "cope and stick" set? If not, whats the difference between the two?...
10 comments posted 20yrs
posted by mike72903
10 comments posted 20yrs posted by mike72903

Mac or any other Turners

How complex is it to make a wood bottle, or container, that has a screw-on top or cap that fits tight and clean to the...
4 comments posted 20yrs
posted by Joe
4 comments posted 20yrs posted by Joe

Need Resources for Selling a Bedroom Set

Sorry to bother you all with this, but my husband and I are selling a beautiful bedroom set made of solid teak. We are...
3 comments posted 20yrs
posted by jurzeygirl
3 comments posted 20yrs posted by jurzeygirl

Beginner needs a ramp

I am very new to woodworking. As a matter of fact, my only project to date has been cutting up an old ping-pong table t...
4 comments posted 20yrs
posted by bakechad
4 comments posted 20yrs posted by bakechad

chamfer my TS wings

While building a cabinet I had to cut some dados using my TS. I taped up the area to be cut with blue tape to prevent c...
6 comments posted 20yrs
posted by NunyaBiznas
6 comments posted 20yrs posted by NunyaBiznas

end coating on drying lumber?

Is any commonly available material suitable? Oil paint? Latex paint? Polyurethane (oil or water)? I only have a small a...
9 comments posted 20yrs
posted by Toller
9 comments posted 20yrs posted by Toller

OT (Humor: Physics)

Forewarded to me by a friend. I thought it well-written and silly enough to not offend - but feel free to re-aim it at...
6 comments posted 20yrs
posted by mrdovey
6 comments posted 20yrs posted by mrdovey

hi - new member - test post

hi, this is just a post to say hello and to test my first post here to make sure it works, o.k. thanks.
6 comments posted 20yrs
posted by rick
6 comments posted 20yrs posted by rick

Hot rod table saw

Hi, The motor on my old Craftsman 10" table saw finally burned up a few months ago. My wife and I are building a house...
47 comments posted 20yrs
posted by nospam
47 comments posted 20yrs posted by nospam

Not For Too Long

When you have not been in the shop for a bit, in this case - three months - things smell funny. Some of this is about t...
1 comments posted 20yrs
posted by notme
1 comments posted 20yrs posted by notme

Re Planer bevel angle

> What angle should a planer blade have? After sharpening, my planer makes > nice looking chips but can barely push the...
0 comments posted 20yrs
posted by srazor
0 comments posted 20yrs posted by srazor

2 degree neagative rake radial arm saw blades

Mike from National Carbide & Tool stopped by the shop today with two pair of radial arm saw blades. I had mentioned to...
4 comments posted 20yrs
posted by juvenal
4 comments posted 20yrs posted by juvenal