what is the general class of this product

Yea , with rustoleum products, if you don't do b4 1 hour or after 48, you wind up with the gassing off causing a really poor finish. I did it one time and found out too.

Just follow the directions and your fine.

I don't use painters touch, but use rustoleum. Dries nice and hard too over time.

i was ending up producing small balls when i sanded instead of dust

the writing is in at least two languages and is tiny so i wing it

this is rustoleum

Electric Comet wrote in news:mvgmdf$kjp$ snipped-for-privacy@dont-email.me:

Rustoleum appears to call it "Acrylic Modified Alkyd", so I'd say you're close enough to right.

Going off on a tangent, has everyone noticed how useless Google has become as a search engine? Pretty much any query will give you a thousand places to buy whatever it is, but actually getting a link that describes a thing is now all but impossible.

John

I usually use Dogpile.com for my search engine. If you're looking for product descriptions and reviews, Amazon.com does a decent job. For descriptions including product specs, I'd try the manufacturer's website.

it's rustoleum in that it's from the same company. But Rustoleum is oil based, and what you are using is not.

you need to sand the stuff with a lubricant. Either soapy water, or something like sikkens m600 paint prep. But I would never sand soon after. It needs to cure.

Swingman turned me on to Duck Duck go, I have never looked back. Just like when I found Google b4 the masses. It was good back then. When you find something that works, use it.

On a completely different tangent, the Rustoleum plant in Evanston Illinois, was sold to Home Depot. I was living in that city at the time, about 6 months after big orange opened they had to drive piles inside of the building cause of all the crap Rustoleum buried on the property. Later they were building a Steak and Shake in the parking lot two days before opening all four walls collapsed.

now i wonder if that kid at the store cares enough to also look it up

have not used google in a long time

ixquick.com startpage.com and others that were mentioned

If you recoat too soon the solvents in the new coat soften/eat/reticulate the old coat. When it IS dry enought to sand, use silicon carbide paper wet on a sanding block.

You don't have a magnifying glass?

"dadiOH" wrote in news:mvik1k$pqc$ snipped-for-privacy@dont-email.me:

In fairness to the Comet, magnifying glasses work much better on flat surfaces than they do on cylinders such as the spray can he's using.

John

it does not like sanding until couple of days later but i got it for the

1 can does go a long away and it is cheap