any idea what current brand of saw table extension would fit on an old Atlas 3060 10" saw? i am looking for an extension for the left side of the table. i don't know if table extensions are some standard size, and i don't have any other table saws laying around to try a piece.
andy b.
snipped-for-privacy@ptdprolog.net (hamrdog) wrote in :
I found an old Delta cast wing and mounted it w/o problem. It is about 2 inches too short front to back. It serves as work piece support, but I've never shimmed it out to extend the fence more left. The real issue is getting it shimmed and true for the front/back locking fence to engage properly. Not that hard just tedious.
Jerry
My first choice would be something like this...
jerry,
thanks for the reply. i'll keep my eyes open and try a Delta extension if one pops up.
andy b.
Data Sheet:
Typical Cross Cut Capacity .............................1" Total Travel ...........................................# 4 Morse Taper Weight (Net) ...........................................390 lbs. Weight (Shipping).......................................467 lbs.
You gotta wonder how well they proofread this stuff :-)
Have something to add? Share your thoughts — no account required.
Ask the community — no account required