If you wanted to make an edge of solid material around a panel, is there an "X" router bit pair where one bit cuts the convex side and the other bit cuts the concave?
Does anyone make a matched pair of "butterfly" bits?
Aug 16, 2003
2 Replies
formatting link
might fill your need. . .
Kim
In a recent FWW, there was an article on just this subject. . .One of the ways goes like this: you center a 45 degree bit on the plywood, deep enough to just touch the outer face veneers. Then you cut solid stock into right triangles of the appropriate size and glue them in.
Kim
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required