I have a mule accusquare table saw fence system.
I am looking to build a router fence to mount to the back side similar
to the one made by Mule
My plan was to get some two inch thick stock mount it to the fence
with some t-slot bolts. On the "outside" of the 2 inch stock I was
going to mount a t-track to allow the attachment of a split fence.
Does anyone see any issues with this? My biggest concern is that
there is no way to remove or adjust the fences without using a socket
set. I would need a socket set since the bolts would have to be
Does anyone have a better way set up a router fence on a t-slot TS
Also what material should I use for this? Unless someone tells me
otherwise I was planing on using mdf