Shower caddy

Jan 18, 2020 Last reply: 6 years ago 10 Replies

Any source recommendations?



Stainless seem unaffordable. Chrome ones rust. Plastic a bit naff.....


stainless steel colander or utensil holder from a kitchen shop (or a charity shop)

Owain

OK chaps. I have what claims to be a stainless twin corner caddy on order from Amazon. £20.00 so we will see!

Equivalent from John Lewis can be £80.00!

When I did my bathrooms a couple of years back, I had to look long and hard to find anything decent made from stainless. In the end they were both from China via Amazon, and to be fair pretty decent quality. (although one was about £40 IIRC).

A handy tip for fitting the corner ones. If they are two shelf ones, they often have uprights that can be fitted either behind the trays, or in front of the trays top rails. Just remember when you mark out the hole positions that if you decide to go for rails behind option after marking out using just the tray as a guide, the holes will be in the wrong place! (DAMHIK)

Ikea 13 quid (other shapes available):

formatting link
Theo

Me? I don't even know what one actually is, are we talking a kind of concave piece of metal with holes in to put soap and other consumables into in a shower? I've never heard them called caddies before. Brian

I have a couple which were reasonable prices. DEFINITELY stainless, either eBay or Amazon.

That sounds similar. Two trays and vertical rails with hooks at the bottom.

I take it the tray goes further into the corner without the rails. I'll be careful. Thanks.

>

Umm.. tempting to get one of those as well. Sadly the shower room does not have a convenient corner.

In message <qvv74t$sjj$ snipped-for-privacy@news.albasani.net>, "Brian Gaff (Sofa 2)" snipped-for-privacy@blueyonder.co.uk> writes

New to me until recently:-)

Yup, this is one of the ones I used:

formatting link

Indeed. If you use the tray to space the rails from the wall then the spacing matches the tray - however if you mount the rails against the wall, then you get the ~4mm offset from the thickness of the rails.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required