Router table - DIY - HomeOwnersHub

Tim Watts · 2011-01-04T22:04:41+00:00

Hi,I feel the need to procure a router - lots of things are coming along this year that will need one or be easier with one.[Background - skip ahead if bored]Been watching router vids on Youtube until my eyes fell out - feel more cluseful...Many of the jobs will be handheld - like door locks and hinges, kitchen worktops - but a few will benefit from a table.Rather than spend an awful lot on a fancy table just to find it is limited, I'd rather start with a flat bit of wood, some T-channel and build up my own, which looks straightforward enough from the vids.But, mine must be collapsable - I have no workshop[1] and limited inside space.So my plan is:2 x Stanley Fatmax sawhorses - these look solid and have adjustable feet - none of my concrete standings are flat or level and I'll be doing routing outside.Some sort of heavy bench top sitting over them withe battens underneath to locate on the sawhorse top rests.Then the router can make its own table - I'll buy ane insert, probably make a fence from ply held down with thumbknobs onto the T-channel. If it seems useful I can add more T channel, to take feather-finger thingies or anything alse that comes along.[SKIP TO HERE]So - the worktop - what to use? I reckon it'll be about 600mm x 1.2 or 1.5m (it has to store easily). It'l going to get routed out, have various holes, probably get stuff screwed to it.It might even get a spot of rain on it so MDF is out.Wooden kitchen worktop (if I can get a short offcut) might be one option. another would be WBP 18mm ply. Not sure how well strip-worktop would handle abuse.Not sure if the ply is stable enough (bendy over 1m span?) but as I'm adding battens for the sawhorse to lock into, I could glue some 4x2" underneath to stiffen it - hoping the 4x2 will not warp itself...Anyone done anything like this before?As to the router - it seems obvious, based on the previous advice here and the vids that if I can only afford one, it should be a lighter 1/2" - probably a Trend or maybe a DeWalt...

Router table - DIY

Jan 04, 2011 22 Replies

Rate this thread:

John Rumm 15 years ago

TS have got the 110V version on clearance:

formatting link

good router in a table certainly...

formatting link

>> (Which is available for 247 inc from Transtools, in theory).

Its got a nice easy to reach depth adjustment knob, which is handy for table use...

This also looks reasonable:

formatting link

the depth adjuster is less accessible.

This is better, but a bit more pricey:

formatting link

assuming this is the same:

formatting link

too far off.

Vote

AlanD 15 years ago

Create a (free) account with

formatting link

and put this file under the \public folder. Create an internet link to it and post here for anyone to download.

Vote

Skipweasel 15 years ago

[shopnotes issue 66]

Someone's already done it - though not with dropbox.

formatting link

|285l35|147057161|ShopNotes_Issue_66.pdf|26758 Searching for shopnotes + 66 + pdf finds plenty already out there.

Anyway - it's got quite a nice design to take a table-saw and router, including room for a shopvac, IIRC.

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required

Router table - DIY

Related discussions

Bread Machine recommendation. Want one NOT made in China.

Harbor Freight Router Table - 91130

[SOLVED] Covering worktop with Fablon (2025 Update)

Join the Discussion

Didn't find your answer?