How do I fit a honeywell replacement power head it's a 3 position diverted.
Plumbing
Feb 21, 2013
3 Replies
I *think* it's just a case of removing the cover (power off first!) and then you should see a couple of slotted dome headed screws holding the baseplate of the powerhead to the water valve. Undo, screw on new one. Connect wires, job done.
Tim
That's right, if it is a removeable one. Honeywell make 2 sorts, and there are lots of the older ones out there. The removeable ones have a small nipple/bump at one end of the top, outer, cover. If you take off the one without a nipple, you'll have a water leak.
In message , Jrwart writes
Since you're posting from diybanter and are obviously too stupid - get a man in
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required