OT Possible cause of van "breakdown"?

Oct 31, 2014 20 Replies
Saved reading

First reply

Cursitor Doom

You were speeding, so the government decided to turn your engine off by remote control. Obvious.

Read the full reply

So I was doing about 90mph in the 3rd lane on a motorway. It's an 09 plate



2.0L Connect

Then I lost all power - ie no revs and a warning light appeared on the dash. I managed to get across to the hard shoulder due in thanks to an HGV driver in lane 1 and no thanks to the cunt in the BMW in lane 2. I had fears that I and the apprentice could die should we have to stop in the 3rd lane.



Now the odd thing is that the engine was running but the accelerator pedal had no effect on the revs. I turned the engine off and restarted the van and all was OK



Any ideas what happened?


limp mode? pay someone down the pub to plug and OBD-II lead into it

You were speeding, so the government decided to turn your engine off by remote control. Obvious.

It's not "limp mode" when you have no power at all. I managed to get back from Prague on limp mode without any problems. This was a total failure of engine power but the engine was still running.

My 2.0 tdci Cmax - is quite similar to the Connect and will go into limp home mode if it thinks there is less that 2 litres of fuel left so there could have been a glitch to cause that and would be reset by a restart.

If a fault is detected in the drive by wire accelerator, it will ignore the accelerator and instead you can drive on the brake pedal. I think gentle pressure on the pedal- enough to put the brake lights on will get it slowly accelerating and harder pressure will slow it down.

I know this mode exists but not sure quite how it works.

Get the fault codes read fairly soon as some get erased after a certain number of successful error free starts.

If you had some accelerator response but not enough power to pull away, then suspect the exhaust gas recirculation valve. These can stick and choke the engine with 100% exhaust being fed into the engine. When you turn off, the software exercises the valve a few times to help stop it sticking and that could explain the trouble free re-start.

I took my EGR valve off and fitted a stronger spring and had no trouble thereafter. Sticking EGR valves do not always register a fault code - mine didn't

Bob

Seriously? What in the name of gawd persuaded them that was a sensible plan...?

Better than not being able to move it at all!

Dying injector. Seen this on a similar age 2.0 TDCi Mondeo. Not mine so only saw it once at startup where it ran but there was no throttle response for a few minutes. Not sure if it happened while in motion. New injector cured it.

Except it doesn't happen. There will ALWAYS be brakes and steering. They might be heavier, without the power assistance, but they will still be "there", and they will still work.

Adrian wrote in news:m32a81$it4$1 @speranza.aioe.org:

I remember years ago being told a tale of a car that would often have its engine die when it reached 60 mph. It turned out to be the label on the radiator that advised that antifreeze was in the system would get drawn upto the air-cleaner intake by the airflow through the engine. This would cut off the intake air. When the car stopped the label would fall back to its "innocent" position. Eventially a mechanic spotted an imprint from the dirt on the label.

I'm glad you worded it like that. You're right. It's a human limitation, not a mechanical one.

Which is why when I change cars, or hire a car, I find a quiet bit of road or a large car park to see what the brakes and steering are like if the engine fails. And push 'er indoors to do the same. It was a real shock to her the time the hire car was a 3.8L Buick Lucerne. And yes, I know I am a SOG :(

ymmv but same haoppenned to me in a citroen.

traced to dodgy connector in fly by wire accelerator. cleaned contacts, fiine since.

Stingers can be deployed anywhere not just at "strategic points". Also a stinger doesn't instantly deflate the tyres, the spikes are hollow tubes with a small hole so it takes a few tens of seconds for the tyres to become flat. So the scroat has a chance of bringing the car to a controlled standstill. Killing the engine at speed is going to apply full engine braking and if the scroat drops into neutral to roll loss of power assisted brakes and steering...

And how does this "power source" only crash the ECU of the scroats car not the one of an innocent nearby car, including the pursuing coppers.

If you have a better answer .............

Just wasn't your day old man (© James Bond).

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required