Multi meter ?

Would something like this be sufficient.

GS38 compliant test prods.

Something like this is often more useful

than a multimeter.

Owain

If that is *really* all you need, I would consider a "volt stick". These have the great advantage of sensing through insulation, and not giving you a "false positive" from inductive coupling (which you can get from a neon).

The same caveat applies as to a neon screwdriver: before assuming something is dead, make sure your device indicates "live" from a known live source. Do this every time you use it.

That covers everything. If you don't need a 10A curent range, so does this at half the price:

NT

That one should hopefully reliably detect live wires, but may sometimes give false-positives.

Most modern multimeters have a very high input impedance on their voltage ranges, so they will sometimes read fairly high voltages (maybe

OP would need to spend a whole lot more for a Fluke. I say get a cheap one and understand the potential issue, which occurs occasionally with almost all multimeters.

NT

A lot of these digital multimeters give spurious readings. An analogue one is better for use on mains electricity. And probably cheaper.

Don't leave the battery in it when it's out of use for more than a couple of days.

I've got a Draper 60792 - easily less than £15 from all the usual suspects. Does everything I've ever wanted from it, and takes abuse. Comes with a very useful rubber cover, and decent quality probes. I would say "I'd definitely buy the same again", but this is my third - they keep hiding, rather than breaking...

That is indeed the correct answer.

If it really is just to be used for mains, I'd go for something like this:-

Easier to use than a meter with two test leads, and safer too.

newshound explained on 07/03/2015 :

I would second that, a wonderful piece of kit if you learn how to use it, understand its limitations and especially the safety implications if it fails to pick up the fact that a live, is actually live.

OMG

have they really got that cheap. How do they pay for the plastics/box/instructions at that price!

I went for as job at Mega a couple of years ago and I got the impression they were still selling theirs for 500 and up

Ok you have all given me plenty of options. Thanks guys.

When they stopped making Avo 8s (also Megger) they were about £1000 inc VAT. I have one.

(I'd be wary of safety with the very cheap ones)

I'd be careful using cheap multimeters on the mains though.

I've got one, which works fine and is surprisingly accurate, but I wouldn't use it on the mains as the fuse is a little glass jobbie and there's virtually no separation between the PCB tracks for the input leads.

It's marked CAT III 600v / CAT II 1000v, but I think they just silk-screen that on all those cheap meters. Fine for low voltage, but no way I'd use it on mains.

on 07/03/2015, Caecilius supposed :

They are OK for mains voltages, but I would not use one for any mains circuit with more than a few milliamps behind it.

Its not just the voltage it is the amperage too, to be wary of.

for the OPs described use I would agree.

Highly unlikely to be cheaper these days.

Days?

Where are you buying your batteries from...?

Quite.

There is an off setting on the DMMs here