I've rediscovered a small 24 VDC motor (dremel sized) that I'd fitted with a "pin chuck" (from 20 years ago!). I was just wondering if dremel accessories would fit? The chuck can take a max diam of 3mm shaft. Would that be too small? Thanks
DIY Dremel
Feb 27, 2006
4 Replies
The max shank on dremel bits is 3.2mm
3mm is the standard shank diameter for small burrs, mounted points, flap wheels etc. 6mm is the shank size for bigger items. Dremel stuff will therefore fit your chuck.
-- Dave Baker
formatting link
*** Free account sponsored by SecureIX.com ***
*** Encrypt your Internet usage with a free VPN account from
formatting link
***
Only a limited amount will fit, the predominent shank size IS 3.2
formatting link
Benjamin Midllethwaite
dave used his keyboard to write :
The pin chucks take jaws of varying size to accomodate different sized accessories.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required