hi guys hope someone can help me with this, when using the cembre hp ratchet crimper which way round should the crimp go into the tool, i ask this because i have seen people use these in different ways.
crimping using cembre hp ratchet crimper
Aug 15, 2020
1 Replies
Is this a "normal" crimp tool for insulated crimps? If so, then the crimp goes in such that the metal part of the crimp is the bit that gets crimped, not the unfilled plastic shroud. See:
formatting link
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required