Home Repair

76591 Threads Posts
to

Clothes dryer burning smell

Last night was doing laundry noticed a really strong burning smell from the garage, went in and it was a nasty smell, n...
9 comments posted 19yrs
posted by murphysf
9 comments posted 19yrs posted by murphysf

Jado faucet cartridge

I need to replcae the cartridges in my Jado bathroom sink faucets. This is the wide seperated type. Can I get these part...
0 comments posted 19yrs
posted by blank
0 comments posted 19yrs posted by blank

Gas Dryer Troubleshooting

Got a dryer that only heats for about 10 minutes then will not ignite for the remainder of the cycles. If I put it on t...
2 comments posted 19yrs
posted by dctdictator
2 comments posted 19yrs posted by dctdictator

All this talk of gas explosions

Has got me thinking of what kind of maintenance does the gas supply to my house require? It was my impression that I am...
12 comments posted 19yrs
posted by m44_master
12 comments posted 19yrs posted by m44_master

Electrical Parts Rip Off

Venting Mode On... I'm feeling a bit ripped off right now. I bought an exterior receptacle box for a GFCI. The box...
6 comments posted 19yrs
posted by teamarrows
6 comments posted 19yrs posted by teamarrows

go kart engine flywheel drags against coil contact

to get a bigger spark, i removed the flywheel, sanded the magnets clean. now, when i tighten the flywheel back on the m...
5 comments posted 19yrs
posted by fuhgettaboudit02
5 comments posted 19yrs posted by fuhgettaboudit02

Massive Natural Gas Explosion "Flips" a House

Last week there was a massive natural gas explosion in Wisconsin that the reporters said actually "flipped" the house....
21 comments posted 19yrs
posted by handyman25
21 comments posted 19yrs posted by handyman25

what is the safest way to climb a roof?

I have a leak in my Cape Cod style house and need to check the flashing around the chimney and dormers. I don't hav...
20 comments posted 19yrs
posted by joe5345
20 comments posted 19yrs posted by joe5345

>45 deg cut.

My miter saw has +/- 45 deg marks. That is, the max "pointedness" I can get is 45 deg. I need to cut a 1" x 2" with a m...
10 comments posted 19yrs
posted by peterv666
10 comments posted 19yrs posted by peterv666

best bang for the buck 42" riding mower?

Subject says it all, almost- I only have a 100x300 lot, but the 3 hours a week with the walk-behind is proving hell on...
10 comments posted 19yrs
posted by aemeijers
10 comments posted 19yrs posted by aemeijers

Shopping for a new washer: Whirlpool vs Roper

I've gotten some good advice from this group, and thought I'd share my recent experience. I had to replace my 1...
12 comments posted 19yrs
posted by robert.macnutt
12 comments posted 19yrs posted by robert.macnutt

pulling flywheel on go kart engine

do you need a special tool? i have a weak spark and i have a feeling it has something to do with the magnet. before i t...
8 comments posted 19yrs
posted by fuhgettaboudit02
8 comments posted 19yrs posted by fuhgettaboudit02