HVAC Discussions

Whole house humidifier: old switch too many amps for HUM terninal

How can I get my old 120V whole house humidifier setup to turn on only when heat is on? I have an old General 1040 bypa...

3 comments posted 12yrs

posted by bryanscholtes

3 comments posted 12yrs posted by bryanscholtes

Yep it is a bit warm

Yes we know it is cold in the Northern hemisphere, but it is rather warm around the centre of Australia http://au.news....

1 comments posted 12yrs

posted by ramrod

1 comments posted 12yrs posted by ramrod

I kind of thought that the truck sounded a bit too large...

from the NY Times "corrections" page A report in the Slap Shot hockey notebook last Sunday about the N.H.L.'s custom-ma...

1 comments posted 12yrs

posted by dannyb

1 comments posted 12yrs posted by dannyb

carrier gas furnace 58DHC055-EC

It has a new circuit board and inducer motor. it operated fine after installing them for about six months. Now the blowe...

1 comments posted 12yrs

posted by ron g

1 comments posted 12yrs posted by ron g

Need CFM for Brundage Fan

My home furnace has a Fan with a sticker from Brundage, Kalamazoo, MI and a type-in (serial/part?) number 26-13391. I h...

9 comments posted 12yrs

posted by vjp2.at

9 comments posted 12yrs posted by vjp2.at

Old Carrier Wall PAC (PTAC) 52xx series Parts source?

Hi, No heat. Suspect heating element is gone. Where to get parts? I understand this units are no longer made.

0 comments posted 12yrs

posted by dragon40

0 comments posted 12yrs posted by dragon40

HE furnace piping question

Shopping for a new gas, forced-air, downflow furnace. Weighing whether a high efficiency furnace is worth the upfront i...

7 comments posted 12yrs

posted by bigxgiantxhead

7 comments posted 12yrs posted by bigxgiantxhead

New Heat Pump - York or Trane?

I'm looking for a little advice. I need to replace my HP and have two quotes so far. The unit will serve the 2nd floor...

0 comments posted 12yrs

posted by MitchNRIC

0 comments posted 12yrs posted by MitchNRIC

Thermostat Tweaking

Greetings, We recently purchased what is seeming to be a POS refrigerator. It's a Frigidaire model 1817LWE and every ti...

7 comments posted 12yrs

posted by nospam

7 comments posted 12yrs posted by nospam

This is Just Weird - Lennox Gas Heater

I've looked for help on other posts, but haven't found anyone with the same symptoms. Hopefully someone can help me out...

5 comments posted 12yrs

posted by Edjamacator

5 comments posted 12yrs posted by Edjamacator

comfortmaker RPJ II, ingiter not getting power/signal, WHY?

I have a comfortmaker rpj II that doesn't heat up, blower turns on runs and kick off. I tested for power there is no po...

4 comments posted 12yrs

posted by andrew

4 comments posted 12yrs posted by andrew

Asbestos or not asbestos?

How are you installers handling the old Residential Octopus furnace removals? I haven't had any of them in a few years...

0 comments posted 12yrs

posted by PPP

0 comments posted 12yrs posted by PPP

Testo 552 micron gauge - You better look for something else.

I got a Testo 552 micron gauge at the same time I got the Bluvac, about which I posted not too long ago. Unlike the goo...

2 comments posted 12yrs

posted by tin_man

2 comments posted 12yrs posted by tin_man

Bluvac - AccuTools - Wow customer service

I recently bought a Bluvac vacuum gauge on eBay. It was listed as new. When I got the gauge, it did not look that new t...

0 comments posted 12yrs

posted by tin_man

0 comments posted 12yrs posted by tin_man

Is Heil any good?

2,500 sq. ft. residential application: My York system finally died. The contractor put together a quote for a Heil syst...

1 comments posted 12yrs

posted by jacopoxy

1 comments posted 12yrs posted by jacopoxy