Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

another hvlp thread

Okay, the last hvlp thread went so well, here's a question I've been meaning to ask. Everyone (ok, not everyone, but no...
28 comments posted 18yrs
posted by noone
28 comments posted 18yrs posted by noone

Best way to repair a solid front door

The front door to my house is ancient, made back in the 1920s and hasn't really been kept up well over the years. I had...
27 comments posted 18yrs
posted by BrianL.Henderson
27 comments posted 18yrs posted by BrianL.Henderson

Lostprophets mp3

The Fender Stratocaster The electric guitar The Fender Stratocaster was designed by George Fullerton, Leo Fender and Fr...
0 comments posted 18yrs
posted by nextelipre
0 comments posted 18yrs posted by nextelipre

dining room table veneer help

I recently purchased an Ethan Allen table which is an espresso finish. My wife left a scented oil thingy on the runner...
3 comments posted 18yrs
posted by zdiddy404
3 comments posted 18yrs posted by zdiddy404

Need source for wood strips

I have a dining room chair with a lattice back made of wood strips approximqtely 1" wide and about .15 mm. thick in a l...
12 comments posted 18yrs
posted by whoozit
12 comments posted 18yrs posted by whoozit

OLD DEWALT TABLE SAW 8.25"

I have one of these and would like to know if its worth anything. I have it mounted on a steel square tube frame with a...
5 comments posted 18yrs
posted by gooeytarballs
5 comments posted 18yrs posted by gooeytarballs

Badly behaving brass

I used to have a wooden sail boat that was made in the 30s. There were several forged iron rings on various spars and I...
2 comments posted 18yrs
posted by dadiOH
2 comments posted 18yrs posted by dadiOH

Floating Tenon Problem

When I make floating tenons the tenon stock is always more tight fitting in the rail (end grain mortise) than in the si...
32 comments posted 18yrs
posted by .
32 comments posted 18yrs posted by .

UHMW plastic question

Anyone have any way to get a thin (no more than 1/8" thick) piece of UHMW plastic to stick to either wood or preferably...
25 comments posted 18yrs
posted by twoblues
25 comments posted 18yrs posted by twoblues

Corner Chisels - large size?

I've got the little magnetic corner chisel from Lee Valley, and I do like it. What I'd really like is to get one that's...
2 comments posted 18yrs
posted by JayPique
2 comments posted 18yrs posted by JayPique

mission style coffee and end table set ...

This is not a request to point me at free plans, though I may look through JOAT's old posts. Instead, please point me a...
1 comments posted 18yrs
posted by larry.levinson
1 comments posted 18yrs posted by larry.levinson

Wood Floor refinishing

I want to refinish the oak hardwood floors in three bedrooms connected by a common hallway. Since I am working by mysel...
9 comments posted 18yrs
posted by noname87
9 comments posted 18yrs posted by noname87

To Turbine or not to turbine

One of my many goals in life is learning how to finish a woodworking project without making myself completely crazy. In...
36 comments posted 18yrs
posted by mboceanside
36 comments posted 18yrs posted by mboceanside