Woodworking Forum

51629 Threads Posts
to

Jointer's - New Purchase

I finally have to give up my Bench Dog router table as a jointer. I waste TOO much time and wood. I am looking at Delta...
8 comments posted 22yrs
posted by mbradley
8 comments posted 22yrs posted by mbradley

Router bits

I'm working on a piece on router bits. Somewhere, I seem to recall seeing a "new" router bit that took inserts similar...
7 comments posted 22yrs
posted by charliediy
7 comments posted 22yrs posted by charliediy

Re-using old redwood

I have this old 100% redwood picnic table that has seen it's days When my Dad made the table some 40 years ago he coate...
4 comments posted 22yrs
posted by stv_euroski
4 comments posted 22yrs posted by stv_euroski

HD Bargan: Porter C 14.4V Cordless Drill $99

HD is running promotion on a Porter Cable 14.4V Drill (Model 9824 3/8"): $99.00. Went there for a DeWalt - $129.00 for...
4 comments posted 22yrs
posted by nospamMCBORUM
4 comments posted 22yrs posted by nospamMCBORUM

Not more trigonometry

John's gloating post about a project REQUIRING a new tool purchase gave me an idea. Since my strange and estranged wife...
23 comments posted 22yrs
posted by agkistrodon
23 comments posted 22yrs posted by agkistrodon

Musings of a Normie

My local PBS station has recently begun to air The Woodwright's Shop. As I sit there watching good ol' Roy hack away wi...
22 comments posted 22yrs
posted by flyer!
22 comments posted 22yrs posted by flyer!

No More Curves

I saw a storage building at a local nursery that had doors with arched tops. Thought it looked good, and incorporated t...
1 comments posted 22yrs
posted by nospam
1 comments posted 22yrs posted by nospam

unwitting "bare bones" purchase

Is this a new trend? I'd been looking at getting a new handheld planer and saw the Makita 3 1/4" at Menards for a few b...
3 comments posted 22yrs
posted by bub209
3 comments posted 22yrs posted by bub209

Good sawmills - northern Minnestoa

Hello - just a shot in the dark but I am looking for a good source of kiln or air dried wood in Northern Minnesota. I l...
3 comments posted 22yrs
posted by kjg
3 comments posted 22yrs posted by kjg

Tenon Width query

Folks - I am making some screen doors out of QS Doug Fir. The bottom rail is almost 10" wide. I am going to go with MT...
1 comments posted 22yrs
posted by johnmoorhead
1 comments posted 22yrs posted by johnmoorhead

shop relative humidity

I have had some problems with rust on my tools (tablesaur, jointer) in my shop in the last couple of springs during the...
8 comments posted 22yrs
posted by fketchum
8 comments posted 22yrs posted by fketchum

Removing rust stain from table saw

Yesterday, I managed to have some water drip down from the open garage door onto my table saw. Of course, I didn't noti...
1 comments posted 22yrs
posted by mschnerd
1 comments posted 22yrs posted by mschnerd

FS: Ridgid 6" jointer - CT

Ridgid 6" jointer, model 610. Mint condition, cared for like a member of the family. Current blades have less than an h...
1 comments posted 22yrs
posted by Keep_it_in_the_newsgroup_pleas
1 comments posted 22yrs posted by Keep_it_in_the_newsgroup_pleas