Woodworking Forum

51629 Threads Posts
to

when to rip?

Suppose you have a perfectly square board, is it still wrong to use a ripfence to cut across grain? How about plywood,...
37 comments posted 22yrs
posted by nospamnospam
37 comments posted 22yrs posted by nospamnospam

Cleaning new carving tools

I just bought a "starter" set of carving tools from Japan Woodworker just to fool around. They have some kind of clear...
10 comments posted 22yrs
posted by wrobertdavis_nospam
10 comments posted 22yrs posted by wrobertdavis_nospam

Plane blades (irons?) for trade

I have a new Hock A2 2&5/8ths inch iron that I would like to trade for an equivalent iron that would fit my Miller Fall...
1 comments posted 22yrs
posted by dhall987
1 comments posted 22yrs posted by dhall987

OT Credit Card Offer

Well, I collected paper from three universities, subscribe to several publications with political leanings, and buy my...
0 comments posted 22yrs
posted by george
0 comments posted 22yrs posted by george

Dust hood contractor table saw

I have found excellent information with regard to assembing a dust hood to fit under my Home Depot TS3650 table saw. I...
3 comments posted 22yrs
posted by kbozek
3 comments posted 22yrs posted by kbozek

a David Marks tip

I saw David do something on a recent show that seems real trivial until I realized that I didn't do it. He was bringing...
9 comments posted 22yrs
posted by e.lowenstein
9 comments posted 22yrs posted by e.lowenstein

net dimension - rough lumber, resawing

As I carefully consider - with substantial help from posts I have read here, TY - whether to buy finished lumber or "ma...
4 comments posted 22yrs
posted by no_spam
4 comments posted 22yrs posted by no_spam

Try the Grizzly shop planner

http://www.grizzly.com/workshopplanner.cfm
2 comments posted 22yrs
posted by kb8qlr
2 comments posted 22yrs posted by kb8qlr

Cutting Tenons on long heavy stock

Does anyone out there have advice to give on cutting tenons on the ends of 4x4 cedar stock? I am planning to build a ar...
12 comments posted 22yrs
posted by mnterpfan
12 comments posted 22yrs posted by mnterpfan

Foundation: Act IV

Folks - Well, for better or ill, the footings are cut for the foundation. The North side trench is okay, it's the south...
0 comments posted 22yrs
posted by johnmoorhead
0 comments posted 22yrs posted by johnmoorhead

FS: ebony

I picked up some Gaboon ebony recently for a project that is not going to materialize. If it was just about anything el...
0 comments posted 22yrs
posted by toddrf
0 comments posted 22yrs posted by toddrf

OSB Prices

I am getting ready to build a small shed (16X24) for woodworking. I noticed this week that the prices of 7/16 OSB in TX...
16 comments posted 22yrs
posted by Elmar66
16 comments posted 22yrs posted by Elmar66

Lumber Gloat

I was unloading some shipping crates from Canada this week that had bottoms made out of 8-foot lengths of 5/8 X 4" T &...
1 comments posted 22yrs
posted by stevec1280
1 comments posted 22yrs posted by stevec1280