Woodworking Forum

51629 Threads Posts
to

feather boards

Does anyone have any plans for a feather board? And is it useful? signature Troy & Michelle Hall Cogy Farm Clay Center,...
4 comments posted 22yrs
posted by green__acres
4 comments posted 22yrs posted by green__acres

Table saw extension?

I've got a very old craftsman table saw. It has a adjustable fence and such but I was trying to cut a piece of plywood...
5 comments posted 22yrs
posted by green__acres
5 comments posted 22yrs posted by green__acres

Edge Bander

Looking for recommendations on a commercial edge bander... what brand and where to buy or lease in USA. Thanks, Lawrence...
1 comments posted 22yrs
posted by jackytar2000MYSPLEEN
1 comments posted 22yrs posted by jackytar2000MYSPLEEN

shellac marks

Hello .. I have been using a clear shellac on stained stairs and a bannister recently and taped things off with low tac...
5 comments posted 22yrs
posted by gob
5 comments posted 22yrs posted by gob

FS, rough sawn teak

I am getting out of the trade and have over 5,000 bf of rough sawn teak, mostly 4/4", 8-14 inches wide, 8-14 feet long....
4 comments posted 22yrs
posted by jeremy
4 comments posted 22yrs posted by jeremy

futon bunk bed

I have been looking for a set of plans for a futon couch that has a twin bed above it. I have a small guest room in my...
2 comments posted 22yrs
posted by sosuok
2 comments posted 22yrs posted by sosuok

Garage bench top suggestions

I recently finished the frame for a 2x4 bench/table using those metal connector brackets and screws available in most h...
16 comments posted 22yrs
posted by spohn
16 comments posted 22yrs posted by spohn

Questions about cherry

I've been working a lot in the past weeks with cherry for the first time. I've obviously discovered many interesting fa...
7 comments posted 22yrs
posted by cyberben
7 comments posted 22yrs posted by cyberben

Semi-OT: again - EMT conduit

On the advice of several - including the local inspector - I'll probably run the new circuits in my garage in EMT condu...
13 comments posted 22yrs
posted by patrick
13 comments posted 22yrs posted by patrick

Best table for Makita miter saw?

I have a Makita LS1013 and I want to mount it in portable stand of some sort. I have to remodel a house, replace lots o...
3 comments posted 22yrs
posted by mbrooks
3 comments posted 22yrs posted by mbrooks

Change hollow core door to solid core door

Hi, Does it exist a solution in the market that can be used to change a hollow core door to become a solid-core door? Th...
14 comments posted 22yrs
posted by leonlai2k
14 comments posted 22yrs posted by leonlai2k

Pricing "?"

I live in mid-Tennessee and build picnic tables from pressure treated lumber as well as roll-back porch swings. These a...
13 comments posted 22yrs
posted by Kroozr
13 comments posted 22yrs posted by Kroozr

Fan curves for Shop Vacs: 150 cfm & 20 inches H2O

We produce a Laboratory meter stand for agricultural seed planters. We need an air movement system that can handle 20 i...
0 comments posted 22yrs
posted by jlkoch
0 comments posted 22yrs posted by jlkoch

WIDE cut sliding miter saws?

I'm curious if anyone makes a sliding miter saw that can crosscut a panel up to 24" wide? Sort of a miniature panel saw...
3 comments posted 22yrs
posted by unknown
3 comments posted 22yrs posted by unknown