Woodworking Forum

51629 Threads Posts
to

Rockwell 28-303 Engaging drive?

I got a 28-303 in nearly new condition for $150. SN 83h11146 which I assume based on other Delta tools indicattes that...
3 comments posted 22yrs
posted by jimbehning
3 comments posted 22yrs posted by jimbehning

Trying to ID chairs

Hello, I'm trying to determine what to call these chairs as to style, type etc. Maybe a guess as to what kind of wood? T...
23 comments posted 22yrs
posted by docsavage20
23 comments posted 22yrs posted by docsavage20

Coffee table with top that can be raised-plan?

At one point I saw a plan/design of a coffee table that looked normal (height wise) but had a feature where by you coul...
3 comments posted 22yrs
posted by JGS77Stamp
3 comments posted 22yrs posted by JGS77Stamp

before or after?

Do you clean your shop before or after you do a project? What's the proceedure for multi session projects. My dad demon...
28 comments posted 22yrs
posted by russbethc
28 comments posted 22yrs posted by russbethc

Router Question

In routering out a slot radius with a 7/8" core box bit, how deep would you recommend to remove in one pass... ie 1/8"...
11 comments posted 22yrs
posted by nottodaythanks
11 comments posted 22yrs posted by nottodaythanks

Black Arkansas stone coming back?

I've always believed that Black Arkansas stone was almost impossible to find, that the veins in Arkansas had been picke...
3 comments posted 22yrs
posted by brocpuffs
3 comments posted 22yrs posted by brocpuffs

Carter Guides Require Bandsaw Guard Replacement

I have an older Delta 14" bandsaw, hex post style, and just bought a set of Carter guides for it. Went to install them...
3 comments posted 22yrs
posted by <michelleeric
3 comments posted 22yrs posted by <michelleeric

What's wrong with this sawblade ?

http://codesmiths.com/dingbat/photos/sawblade.jpgFriend of mine showed me this at the weekend. It's a 7 1/2" CMT thin k...
4 comments posted 22yrs
posted by dingbat
4 comments posted 22yrs posted by dingbat

Drill press jig question

I'm trying to cut a handle (square rectangle rounded at both ends) in a board. I was doing this with a 1" spade bit. Ba...
10 comments posted 22yrs
posted by rajkalex
10 comments posted 22yrs posted by rajkalex

OT: Roof Vent

I want to install a 6" roof vent for a range hood and I could use some advice. Do I actually need to remove some shingl...
2 comments posted 22yrs
posted by me7
2 comments posted 22yrs posted by me7

Office Furniture Plans

Hello, Just finished remodeling my office. It's not large -- about 12x12. I'd like to find a source of plans to build t...
1 comments posted 22yrs
posted by azwood
1 comments posted 22yrs posted by azwood

finish nailer

I'm in the market for a finish nailer to be used "recreationally" for installing trim and building furniture. Anyone hav...
5 comments posted 22yrs
posted by walshsw
5 comments posted 22yrs posted by walshsw

shocking table saw

I have an old Craftsman table saw that has an external motor. It runs the blade via two belts. it only has a 2 wire non...
79 comments posted 22yrs
posted by green__acres
79 comments posted 22yrs posted by green__acres