Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

refinishing rubberwood -- how hard is it?

Hi, I'd like to buy some chairs made out of rubberwood from Crate & Barrel ($50 on sale) and refinish them because I do...
1 comments posted 20yrs
posted by johnbkim
1 comments posted 20yrs posted by johnbkim

Making a straight tunnel through hardwood

Hello, All! I recently found some timber washed up on the beach here a NS Mayp0rt I decided to take the pieces home to...
8 comments posted 20yrs
posted by bwickes
8 comments posted 20yrs posted by bwickes

Delta-Multiplex 20A

50ish Delta Multiplex 20A available in San Francisco, CA E-Mail me off group at snipped-for-privacy@Mindspring.com If in...
0 comments posted 20yrs
posted by Pilgrim6nospam
0 comments posted 20yrs posted by Pilgrim6nospam

Spray gun recommendations

I need to get a spray gun(s) for stain and finish (urethane) for "recreational" use (non-commercial,. hobby projects) Y...
10 comments posted 20yrs
posted by ranchjp
10 comments posted 20yrs posted by ranchjp

I've Been Away

...for a while and now I'm back for a while. I wonder if anyone has used an airbrush to selectively apply dark stain to...
5 comments posted 20yrs
posted by llhote
5 comments posted 20yrs posted by llhote

Ataboy Hitachi

I bought a Hitachi 12V router about a year ago. I removed the plunger springs and mounted it in the side table of my Un...
3 comments posted 20yrs
posted by gmyers9(NOSPAM)
3 comments posted 20yrs posted by gmyers9(NOSPAM)

Re-calibrated my TS

SWMBO was busy last weekend so I had an entire day to do nothing but play in the shop. I'm between projects right now,...
1 comments posted 20yrs
posted by jcaron2
1 comments posted 20yrs posted by jcaron2

Woodslicer band blades from Highland Hardware

Wow, first resaw of a 2x10 pine board for practice is darn near close enough to sand out the finish. I'm impressed
22 comments posted 20yrs
posted by knot
22 comments posted 20yrs posted by knot

When the "heirloom piece" line is crossed.

I know there's no hard and fast rules on this subject but I think common sense should have some bearing. The other week...
37 comments posted 20yrs
posted by foggytown
37 comments posted 20yrs posted by foggytown

FLUTING JIG

Hello, All! It looks like I answered my own question. Here is the design I have come up for a fluting jig. (Power Point...
5 comments posted 20yrs
posted by bwickes
5 comments posted 20yrs posted by bwickes

Advice needed for 9'x22" Rail and Stile.

Should I use free hand routing or on a router table? I am afraid I cannot do a good job on my router table as the 9 fee...
1 comments posted 20yrs
posted by newguy
1 comments posted 20yrs posted by newguy

Stryped - Bed Update

Dear Stryped, How is your bed coming out?
6 comments posted 20yrs
posted by frankdrack
6 comments posted 20yrs posted by frankdrack

Bandsaw Blade Tracking

I have a delta 14" bandsaw with riser blocks. For the last couple of months I couldnt cut a straight line to save my li...
9 comments posted 20yrs
posted by howard
9 comments posted 20yrs posted by howard