Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

Kiln dried, but the ends aren't sealed.

Or at least, they probably aren't. In a few days I'm going to go look at a load of Black Walnut someone had cut off her...
1 comments posted 20yrs
posted by else24
1 comments posted 20yrs posted by else24

Multico TM1 Tenoner

Hello, Does anyone know where you can get parts/manuals/tooling for this machine? Thanks.
0 comments posted 20yrs
posted by ogplusone
0 comments posted 20yrs posted by ogplusone

Multico TM1 Tennoner

Hello, Does anyone know where you can get parts/manuals/tooling for this machine? Thanks.
0 comments posted 20yrs
posted by ogplusone
0 comments posted 20yrs posted by ogplusone

Table Saw & Router Combo

I'm in the market for a Table Saw / Router / Sander / etc. Combination and am not sure which to get. I want to get a "g...
6 comments posted 20yrs
posted by samadams_2006
6 comments posted 20yrs posted by samadams_2006

Fein MultiMaster question: (Lew?)

I cross-posted it as I look for my favourite experts in both groups. I'll never do it again... promise. I have been ask...
4 comments posted 20yrs
posted by design
4 comments posted 20yrs posted by design

RAS leftovers

So, through a couple of transactions, I picked up a nice old RAS, no base but solid. Then, bought a newer RAS with base...
3 comments posted 20yrs
posted by NOchipSPAMchester
3 comments posted 20yrs posted by NOchipSPAMchester

Iron Required

My new project http://www.connoraston.com/albums/18-03 is made up from 2 x 3/4" mdf maple veneereed panels sandwiched t...
6 comments posted 20yrs
posted by ca
6 comments posted 20yrs posted by ca

Oil Finish

Im working on a cabinet at the moment and am using Osmo Polyx Oil for the second time, as a finish. http://www.agwoodca...
1 comments posted 20yrs
posted by ca
1 comments posted 20yrs posted by ca

dating oriental gals

Wild Thais, divine Vietnamese, devoted Filipinas... and lots more; find your dream gal rather than living nightmare at:...
2 comments posted 20yrs
posted by gelarace
2 comments posted 20yrs posted by gelarace

Re how much to charge for woodworking work

I won't get near a project unless I can clear $25 an hour (that is after taking out overhead and profit, it's a busines...
1 comments posted 20yrs
posted by srazor
1 comments posted 20yrs posted by srazor

OT humor: Lone Ranger

Some hours later, Tonto wakes the Lone Ranger and says, "Kemo Sabe, look towards sky, what you see?" The Lone Ranger re...
2 comments posted 20yrs
posted by jo4hn
2 comments posted 20yrs posted by jo4hn

Is your plane iron too soft?

It seems my heat treaters seem to have let me down. I have found atleast a few soft irons. I know they started around 1...
16 comments posted 20yrs
posted by stevek
16 comments posted 20yrs posted by stevek