reverse ogee plunge bit?

Question

I want route this profile into a flat surface, to make a dished out area. The only plunge ogee bits I can find have a step detail halfway up. Any ideas?

HHHH####ddoo,__. MMMMMMMMMMMMMMMMM#bo. MMMMMMMMMMMMMMMMMMMMMHb\ MMMMMMMMMMMMMMMMMMMMMMMMHb_ MMMMMMMMMMMMMMMMMMMMMMMMMMMHb. MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMH\. MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM#\ MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMb\ MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM#o_. MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMH##oo,__.... MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM

Upscale · Accepted Answer

?c=1&p=30135&cat=1,46168,46178&ap=1

Upscale · Answer

Upscale · Answer

should give you what you're looking for.

Nova · Answer

MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM

See:

formatting link

DJ Delorie · Answer

Nova  writes:

Larry Jaques · Answer

On 25 Sep 2009 18:14:54 -0400, the infamous DJ Delorie scrawled the following:

Are you sure you don't want a raised panel door bit? That's what your illustration looked like to me.

formatting link

cheap import or

formatting link

Freud

DJ Delorie · Answer

Neither of those can "dish out" a region of the wood - they have bearings, so they can only cut along the edge. Also, the import one wouldn't have left a continuous curve at the top - there'd be a corner.

The freud one has nearly the right curve though.

Larry Jaques · Answer

On 30 Oct 2009 22:59:46 -0400, the infamous DJ Delorie scrawled the following:I must have missed something in your original post. I thought youwanted -edge- treatments.

reverse ogee plunge bit?

Join the Discussion

Didn't find your answer?