Joe,
Thank you! I had not c>Instead of using the boards flat/curved turn them on edge. this gives you
several inches to cut one or more curves from. You'll need more slats
>closer together, but I've seen chairs made in this style at prices I can
>only hope to afford.
>Tip cut a cardboard or masonite template to test the curves, 1 template
>for each board across the back, against several peoples backs, unless
>making a custom chair for 1 person.
>Joe
>
>Oughtsix wrote:
>> I just picked up a load of IPE T&G flooring cutoffs. They range in
>> length up to 4'. I would like to build some indoor/outdoor furniture
>> with it. For the backs of the chairs I would like to have a slight
>> bend in the wood to make them more comfortable. Has anyone ever steam
>> bent IPE? Am I crazy for even considering trying? I know that I
>> could laminate a couple of pieces together and cut the bend I want on
>> the bandsaw but I would prefer a single bent piece.
>>
>> I am also considering planing the lumber thinner and glueing a couple
>> of laminanation together over a curved form but I am a little worried
>> about eating up my planer blades.
>>
>> Any suggestions?